Corrosion Resistance Level Sensor
ULB7 corrosion resistance level sensor is made by using imported high accuracy and stability ceramics sensors, and through precise structural design and temperature compensation, signal amplified and V/I transforming. Its PVDF material housing is full sealed design. The cable of ULB7 corrosive level sensor is put in PTFE pipe, simultaneously with breathing pipe which makes sensor's back pressure intensity connect to atmosphere pressure.
ULB7 corrosion resistance level sensor is entire solid state products with standard 4~20mA or 0~10mA signal output.
●Suitable for corrosive media measurement like strong acid or strong alkali.
●Anti-interference, good long-term stability.
●PVDF housing, PTFE cable.
|output signal||4~20mA, 0~5V, 0~10V, 1~5V, 0.5~4.5V|
|accuracy||0.25%FS, 0.5%FS (standard)|
|load resistance||RL=(U-12V)/0.02A(4~20mA current output) U—loop voltage(V)|
|compensated temperature range||-10~+70℃|
|operating temperature range||-40~100℃|
|temperature coefficient of zero||0.25%FS/10℃|
|temperature coefficient of span||0.25%FS/10℃|
|electrical connection||Φ9mm shielded cable with vent hose(PTFE)|
|material of pressure membrane||ceramic (other materials are available on request)|
|material of wetted part and housing||PVDF|
ULB7 corrosive resistance level sensor has been widely used for static or dynamic level measurement of corrosive liquids as strong acid or strong alkali etc in refinery, chemical plant, glass factory, Sewage treatment plant and so on.